Skip to content
Quantum.world

The Signal

Researchers report entanglement swapping across New York fiber

A published experiment used 17.6 kilometers of deployed fiber between Brooklyn and Manhattan for entanglement swapping. The researchers reported different rates for the city network and a local configuration.

Researchers report entanglement swapping across New York fiber

Researchers have reported entanglement swapping across 17.6 kilometers of deployed commercial fiber between Brooklyn and Manhattan, using independent photon sources and a central measurement hub, according to a paper in PRX Quantum. The team reported a separate, higher swapping rate in a local configuration, with all the equipment in the same building.

Source link.aps.org

The paper, published November 10, presents experiments by researchers affiliated with Qunnect, New York University and Cisco Quantum Labs. The city test used a hub-and-spoke arrangement: the sources remained in Brooklyn while the hub was placed in a Manhattan data center.

Two settings, different rates

In the field experiment, the researchers observed a Bell S-parameter above 2 at measured swapping rates exceeding 0.65 events per second. After accounting for the spoke detectors’ 65% detection efficiency, they said the measurement corresponded to a swapping rate above 1.5 events per second.

The local experiment also produced an S-parameter above 2, at measured swapping rates exceeding 200 events per second. Applying the same detector-efficiency adjustment, the researchers reported a corresponding rate above 470 events per second. The higher figure therefore belongs to the local configuration, not the deployed city fiber.

The paper uses the Bell S-parameter as a measure of swapping fidelity and examines how it changes with the measured rate. For each experiment, the team reanalyzed its data using different regions of interest for coincidence measurements.

How the network was arranged

The field setup had two source nodes in separate rooms at the Brooklyn Navy Yard and a hub at QTD Systems’ data center in Manhattan. Each spoke was connected to the hub by about 8.8 kilometers of fiber, according to the experimental account. For the local test, the hub was placed with one of the source nodes.

At each spoke, an independent source used warm rubidium vapor to generate photons. Each source produced entangled pairs at wavelengths of 795 and 1324 nanometers. The 1324-nanometer photons traveled to the hub over the deployed fiber, while the other photons were measured at the spokes.

There, a Bell-state measurement interfered with the incoming photons from the independent sources, projecting the remote 795-nanometer photons into an entangled state. The process is intended for applications including quantum repeaters, distributed quantum computing and quantum sensing, the paper states.

Detectors and controls

The spoke nodes were designed to operate at room temperature and used single-photon avalanche detectors. The hub instead used superconducting nanowire detectors requiring cryogenic cooling. The experiment did not share lasers or optical frequency references between nodes and did not require the sources to be pulsed.

For the city experiment, automated polarization compensators checked for fiber drift every thirty seconds and corrected it when needed. Before swapping over the network, the team reported that the measured pair rate for single-fiber entanglement distribution remained stable to plus or minus 5% over 30 hours.

A separate classical fiber network carried data collected by time-tagging devices. The team used the White Rabbit protocol to synchronize those devices, while Cisco’s Quantum Network Orchestrator centrally controlled the experimental nodes.

Sources

  1. American Physical Society
  2. arXiv
  3. American Physical Society

Related stories

Explore

More articles