Skip to content
Quantum.world

The Signal

Microwave photons cross 30 meters in three selectable pulse shapes

Superconducting quantum circuits sent microwave photons in three orthogonal temporal modes across a 30-meter cryogenic link. Matching the receiver’s absorption pulse to the photon’s mode produced transfer efficiencies of 75% to 79%, while mismatched modes were mostly reflected.

Microwave photons cross 30 meters in three selectable pulse shapes

A photon’s shape becomes a choice

Superconducting quantum circuits sent individual microwave photons in three distinct temporal modes across a 30-meter cryogenic link. At the receiving circuit, researchers selected which mode to absorb by choosing a matching control pulse. The experiment demonstrates that a photon’s temporal shape can act as a selectable degree of freedom in a quantum network.

Source journals.aps.org

The modes, labeled f0, f1 and f2, are mutually orthogonal: their waveforms are distinct, allowing the receiver to absorb a photon in one mode while reflecting photons in the others. The researchers used shaped control pulses to generate the photons. They tracked the source qubit’s population during emission to characterize the photon shapes indirectly. In that measurement, they stopped the emission pulse at different times and read out the qubit. Its ground-state population rose from zero to one as the pulse released the photon; the higher-order modes showed flat intervals in the population dynamics, corresponding to nodes in their waveforms.

Matched modes transfer; others reflect

For the transfer test, one circuit emitted a photon and a second applied an absorption pulse. The team varied the delay between the pulses and tested all nine combinations of emission and absorption modes. They measured the receiver qubit’s excited-state population as an indicator of transfer.

When the emission and absorption modes matched, transfer efficiencies ranged from 79% to 75%, declining weakly as the mode order increased. With different modes, the receiver’s excited-state population was between 1% and 4% near the optimal absorption delay, indicating that most of the photon was reflected rather than absorbed. The researchers report a selectivity ratio of about 40, or 16 decibels, calculated from the average transfer for matching modes compared with the average for mismatched modes.

The transfer measurements used a photon bandwidth of 24 megahertz. The optimal delay was 145.9 nanoseconds, with an uncertainty of 0.2 nanoseconds. The researchers say this is consistent with propagation through the 30-meter waveguide at about 0.72 times the speed of light, with additional delay from roughly 80 centimeters of coaxial cables connecting the waveguide to the devices.

Losses and potential uses

A model fit to the measured transfer data yielded a photon-loss probability of 17%. The researchers attribute the loss mainly to resistivity and impedance mismatches at the chip-channel interfaces, control-pulse errors and qubit decoherence. They report that attenuation in the waveguide itself was below 1 decibel per kilometer.

The researchers say orthogonal temporal modes could provide a way to encode photonic qubits for detecting and correcting photon loss. They also describe routing photons between multiple nodes connected to a shared bus, with a mode indicating the intended destination, as a potential application. They note that direct application to multiplexed communication appears challenging at present. The study also finds that a mismatched absorption pulse can distort a reflected wavepacket.

Sources

  1. Physical Review Letters (American Physical Society)
  2. arXiv

Related stories

Explore

More articles