The Signal
Tokyo and NYU Team Develops Electrically Tunable Superconducting Junction
A University of Tokyo and New York University team built a semiconductor junction combining superconductivity and magnetism. The device showed gate-controlled supercurrent and magnetic-field-dependent behavior, including a superconducting diode effect.

Combining magnetic control and superconducting pairing
Superconducting circuits carry current without electrical resistance, but their usefulness also depends on controlling the quantum phase, which describes the collective rhythm of paired electrons. Magnetism can alter that phase, offering a potential route to superconducting memory and quantum circuits that require fewer external magnetic controls. Combining magnetism with superconductivity is challenging because magnetic alignment of electron spins can disrupt the Cooper pairs that carry a supercurrent. Semiconductors can help researchers study and control this interaction because their electrical properties can be adjusted with a gate voltage. Making such devices requires exceptionally clean interfaces between materials with very different properties.
Source t.u-tokyo.ac.jp
A semiconductor device with a clean interface
A research team from the University of Tokyo and New York University developed a hybrid semiconductor device that brings these capabilities together. Hirotaka Hara and Lukas Baker led the team, with supervision by Masaaki Tanaka, Javad Shabani and Le Duc Anh. The researchers grew a layer of superconducting aluminum above an indium arsenide semiconductor channel, with a magnetic layer of iron-doped gallium antimonide below it. They grew the layers in ultrahigh vacuum without exposing them to air, preserving clean interfaces. Electron microscopy confirmed an atomically sharp and clean interface between the aluminum and the semiconductor.
A gate controls the junction’s supercurrent
The researchers made two aluminum electrodes with a 100-nanometer-wide gap between them, leaving the semiconductor as a bridge. This structure is called a Josephson junction. Superconducting correlations from the electrodes extend into the semiconductor, supporting a resistance-free current through the bridge. At 30 millikelvin, just 0.03 degrees above absolute zero, an ungated device carried approximately three microamperes without resistance. Applying a negative gate voltage reduced the number of electrons in the channel and decreased the supercurrent. The result demonstrates electrical control of superconducting transport in the semiconductor junction.
Magnetic response and a superconducting diode effect
The devices also showed an unusual response to an applied magnetic field. The maximum resistance-free current rose and fell in an interference pattern depending on the direction in which the field was swept. This dependence on magnetic history is consistent with a magnetic contribution to the supercurrent. That contribution may be associated with magnetism induced in the indium arsenide channel by the neighboring magnetic semiconductor; the reported measurements point to a possible connection rather than establishing that explanation as the cause.
The current limit also differed between opposite current directions, producing a superconducting diode effect with efficiency up to 20% under an applied magnetic field. At a suitable current, the junction can remain superconducting in one direction while becoming resistive in the other. Together, these results show gate-controlled supercurrent alongside magnetic-field-dependent behavior in the same device.
A platform for studying the interaction
The clean interfaces, gate control and signs of magnetic influence provide a platform for studying how superconductivity and magnetism interact in semiconductors. Together, the clean interfaces, gate-controlled supercurrent and signatures of magnetic influence offer a path toward semiconductor-based superconducting devices for quantum electronics. The study is listed in Communications Materials as “Interplay of superconductivity and ferromagnetism in ferromagnetic-semiconductor-based Josephson junctions.”
Source
Related stories
- Adelaide Team Reworks SQUID Arrays to Detect Zero Field
- Terahertz Light Separates Electron and Hole States in Vortex Cores
- UTe₂ Measurements Establish a Tetracritical Point at 0.20 GPa
- Twist-angle-dependent quantum phases mapped in bilayer MoTe₂
- Quantum team tests monopole-scattering analogue on Quantinuum H2