Skip to content
Quantum.world

The Signal

MIT team demonstrates superconducting memory and signal-control device

MIT researchers demonstrated a layered superconducting device that stores a bit without continuous power and can steer electrical signals. The device also worked as a superconducting diode, but it still needs extremely low temperatures and has not yet been tested in a large memory array.

MIT team demonstrates superconducting memory and signal-control device

A layered cell for cryogenic memory

A superconducting device demonstrated by researchers at MIT can store a bit without continuous power and steer electrical signals, according to an MIT News account published November 20. The device combines an ultrathin superconducting film with magnetic layers, a structure the researchers say could provide both memory and signal control in superconducting circuits.

Source journals.aps.org

The work is described in a paper in Physical Review Letters, published October 5, titled “Magnetic Exchange-Coupled Superconducting Devices with Broken Symmetry for Cryogenic Memory.” Senior research scientist Jagadeesh Moodera and colleagues, including first author and postdoc Josep Ingla-Aynés, describe the device.

How the bit is written

The device places a superconducting film between two magnetic layers. The relative alignment of the magnetic layers determines whether the film is superconducting or resistive: in MIT’s description, current passes when the magnetization points in opposite directions, while the film becomes resistive when the directions match.

To write a bit, the researchers apply a small magnetic field and an electrical pulse that briefly heats the selected cell, making its magnetization easier to switch. At the cell’s operating temperature, whether current can pass represents one of two states, read as a zero or a one. Once set, the magnetic alignment remains without a continuing pulse or applied field, so the cell retains its state without a constant electrical supply.

MIT reported that the team switched one cell without changing a neighboring cell. The MIT account says changing the magnetic alignment in these cells takes less energy than encoding a bit in traditional semiconductor cells, but it gives no system-level energy-savings figure.

Signal control and remaining work

At a lower temperature, the device can also act as a superconducting diode. Within a particular range of currents, it lets current flow without resistance in one direction while resisting it in the other; changing the magnetic alignment can reverse the preferred direction or set the device to an off state.

The device must remain extremely cold to operate, MIT said. Its demonstrated memory stores regular bits, not qubits, though the researchers say the structure could potentially provide memory and signal control for supporting electronics in quantum computers as well as in conventional computers.

The next steps are to make the devices smaller, combine them into arrays that can store more information and quantify the energy savings in a system built from them, according to MIT. The researchers have demonstrated an individually switchable, nonvolatile memory cell; the account describes larger arrays and their system-level performance as future work.

Sources

  1. Original source · Paper American Physical Society journals.aps.org

Other pages read

  1. MIT News news.mit.edu

Related stories

Explore

More articles